中国空间科学技术

• • 上一篇    下一篇

GPS L5信号捕获方法的研究

张璐;张庆君;   

  1. 中国空间技术研究院总体部;
  • 发布日期:2008-10-25

Research on GPS L5 Signal Acquisition Method

Zhang Lu Zhang Qingjun(The System Design Department of China Academy of Space Technology,Beijing 100094)   

  • Online:2008-10-25

摘要: L5信号是全球导航定位系统(GPS)新增的一种民用导航信号,它具有码速率更高、码长更长的特点。在星载高动态环境下,采用传统方法捕获L5信号捕获时间过长,因此文章提出了一种匹配滤波结合快速傅立叶变换(FFT)的捕获方法,该方法能够同时搜索码相位与载波多普勒频率,从而加快了捕获速度。理论分析和仿真结果表明,这种捕获方法适用于码长较长、多普勒频移较大的环境,通过对各种码长分段方式的分析比较,文章选出一种最合适的分段参数,能够满足L5信号的捕获要求,最后采用FPGA对该方法进行了硬件设计,验证其硬件可实现性。

关键词: 快速傅里叶变换, 多普勒频率, 捕获性能, 数学模型, 全球定位系统

Abstract: L5 signal is a new civil navigation signal adopted by Global Position System since it has better navigation performance because of higher code rate and longer code length.The traditional acquisition method results in long acquisition time,especially under high dynamic circumstance on board,so a matched filter combined with FFT acquisition method was proposed,which could search the code phase and Doppler frequency at the same time,therefore reduced the acquisition time.The theoretical analysis and simulation results show that,this acquisition method is suitable to long code in large Doppler offset situation.Based on the comparison among various subsection methods,an appropriate subsection method which could satisfy the acquisition demand of L5 signal in GPS system was chosen.Finally,the acquisition experiment was implemented using a FPGA,tests were then conducted to verify and validate the method.